Re: I Don't Want A Machinist To Modify "My Part" / Why Would A Machinist Need To Modify A Customers Part?

On Thu, 7 Aug 2008 09:43:09 -0700, "John R. Carroll"
<jcarroll@[EMAIL PROTECTED]
> wrote:

>>
>> What does common sense say when a gage always reads ZERO? There is an
>> issue. What does Jon say?  What gage.....LOL..the only gage I see
>> always reads zero.
>
>It must be an integrity meter.
>I wonder if the reading changes when somebody else checks it?

It flabbergasts me that Jon poses as an expert but doesn't even know
the basic's about machine care & operation.

Jon is according to his posts operating a machine but doesn't even do
basic operator checks. He can't do basic machine checks if he doesn't
know what the ****ing gages are for? 

Basic daily checks (quick and dirty not complete):

   Before power up:

All oil levels
Coolant level, refract
Coolant tank (skim tramp oils, clean/remove grit)
Air, Air pressure, filter trap & oilier
Cabinet Filters
Check/Clean coolant screens and drain passages & chips 

  Power up:

Check pressure gages
Warm up procedure

How can you possibly operate and care for a machine properly and NOT
know what the gages are for or what they should read?

Tom