Re: Machining Tips!

Cliff wrote:

> On Sat, 19 Jul 2008 12:37:19 +0000 (UTC), Black Dragon
<bd@[EMAIL PROTECTED]
>
> wrote:

>>Cliff wrote:

>>>   Great idea. You programmed a hole to drill in the default X-Y plane
then
>>> generate it with an isometric view & WCS/MCS active.

>>See, you're incapable of understating basic Mastercam functionality due
>>to your lack of experience with it.

>>But you've never let lack of knowledge about something deter you from
>>posting stupid ****.

>   I'm not the one that wanted it to work that way <G>.

It doesn't work that way. It can't work that way because the way you
explained it doesn't make any sense at all. That was my point.

>>Don't let me get in the way though, feel free to continue.

>   Or complained that it did not.

Please feel free to demonstrate some more of your ignorance for the
audience.

-- 
Black Dragon

If a child annoys you, quiet him by bru****ng his hair.  If this doesn't
work, use the other side of the brush on the other end of the child.