On Sun, 8 Jun 2008 16:07:24 -0700 (PDT), jon_banquer
<jon_banquer@[EMAIL PROTECTED]
>
wrote:
>
>How long before you figure out how limited SolidWorks is when you have
>to work with someone else’s design and modify it without blowing away
>the models history?
So the answer (rather than learning how to actually use SolidWorks)
is to A) blow away the history by im****ting it into SE?
Then, I expect, you will be im****ting it into MasterCAM to
change?
LMAO !!!
--
Cliff
