Re: SW & MasterCAM

On Tue, 13 May 2008 00:34:41 -0500, "mark" <mark@[EMAIL PROTECTED]
> wrote:

>
><barn_rubble@[EMAIL PROTECTED]
> wrote in message 
>news:df6c3ee1-b761-4da5-9cc2-e0d0f221ab19@[EMAIL PROTECTED]
>>
>>> > To clarify, I paid nuttin' because it's installed at work. So I
didn't 
>>> > pay
>>> for it. But the problem is the only guy who knew MasterCAM quit, and
no 
>>> one
>>> else knows how to use it. I thought I'd be able to help out by picking
up
>>> the basics, at least.
>>
>>
>> try this
>>
>> http://eapprentice.net/lessons.html
>>
>> Barn
>Thanks Barn, these will be a good start. Just what I was looking for. 

  You'll know more than a banquer in  few days <G>.
-- 
Cliff