On Tue, 06 May 2008 22:22:55 -0700, gk <glkd@[EMAIL PROTECTED]
> wrote:
>
>
>jon_banquer wrote:
>> I sure hope Mastercam X3 is better coded than X2. I cranked out 6
>> programs today.
But did he drill all 6 holes in the right places? How much
time can he spend doing MDI edits at the control?
>>Had to kill Mastercam and restart it 4 times. ****
>> just stops working. Example: I'm chaining and wish to move the start
>> point. The move start point dialog box won't open until I kill
>> Mastercam X2 MR2 SP1
But it works just fine if it's not running, right?
>>(latest download from CNC Software's website) and
>> restart.
He should be certain to pull the same dumb blunder
again & reboot again.
>> Jon Banquer
>> San Diego, CA
>>
>I smell operator error!
Me too & it stinks from here.
I do trust he never claimed that he could actually use it.
He's never been able to actually use anything else
either AFAIK.
>It works OK here. Sorry Jonnie, but I do
>actually use the pgm.
>
>gk
>
He's always good for a laugh.
Always rebooting the demo & whining.
--
Cliff
