Peter wrote:
> Walther,
> I followed your suggestions but I can't get the solid extrusion to
> trim (greyed out).
> TRIM is only available when a SURFACE is selected, not a SOLID.
> I tried to make the extrusion into a SURFACE but the result isn't what
> I wanted.
> Thanks for your help
> Peter
>
Donīt mix surfaces and solids in ProE - entirely different approaches.
Canīt "trim" a solid. As I told you, the name for it may have changed,
earlier on it was "feature", "create", "cut", "use quilt" for a solid
to be trimmed using an offset surface or "feature", "create", "solid",
"use quilt" fore a more sophisticated one (i. e. the complete logo
made up from an offset surface).
You will then enjoy to select all tangential edges of each logo letter
for neutral curves ...
"feature","create","tweak","draft","neutral curve" back in 2001.
Sorry if this is not of much help in WF eventually.
Walther
|
