"Aggrevated" <tclement@[EMAIL PROTECTED]
> wrote in message
news:bbaf82f8-3e28-4cc9-9b57-e78c2427f9f6@[EMAIL PROTECTED]
> Ok, I guess that makes sense. I like parametrics cause I'm lazy. A
> little work in the beginning automating everything saves a bunch of
> time later. However, putting relations in to calculate titleblock
> info seems a bit overkill.
>
> However, our title block standard tolerances change constantly. Some
> parts will be .xxx=.005 others .xxx=.001 yaddayadda.
>
How do you do this variation in the customary units? It's got to be as
***bersome there because linear_tol_0_00 is a Pro/e system parameter, not
a
user defined one. It goes in the config.pro file which applies to every
file
created. And, if you change it in config.pro, it changes it in every file.
So, how are you customizing this? User defined parameters?
Anyway, relations, built into the part, would just take this value and
convert it with some factor and, at the same time, create a parameter that
would be used in the format so that any time you changed the value of the
customary units tolerance value, you'd get the automatic conversion to
ISO.
David Janes
> Here's the problem. We're always "tinkering" with our title block
> formats. So, when we go in to swap to the new title block, you have
> to adjust the standard tolerances on every sheet. This irritates me.
>
> Well, I guess you can't have everything.
|
