by "Janes" <djanes@[EMAIL PROTECTED]
>
Feb 25, 2008 at 07:15 PM
"Ben & Mickie Loosli" <looslib@[EMAIL PROTECTED]
> wrote in message
news:13s6sohmc6dvh73@[EMAIL PROTECTED]
>
> There is a TPI on www.ptc.com that explains how to edit the hole file
> callout format.
I'm sure you're right, sure I've seen it somewhere, but after an hour of
perusing the PTC KB, couldn't find it, much less, whether it was
configurable. Everything seemed to be about hole charts, not the standard
hole parameters.
¡Muchas gracias!
David Janes
