On Aug 26, 9:29 am, AG <agaurav...@[EMAIL PROTECTED]
> wrote:
> On Aug 26, 1:35 am, Riad KACED <riad.ka...@[EMAIL PROTECTED]
> wrote:
>
>
>
> > Dear AG,
>
> > I do agree with St=E9phane, you should escape the " with an \ when
your
> > stings are within the monteExpr command.
> > So the following syntax:
> > monteExpr( "avgIvdd" "average(clip(IT(\"/V6/MINUS\") 1n 4n))" )
> > should be fine. I don't see any problem with the IT command as well.
>
> > I was checking one of my oceans just now, and did successfully run a
> > script containing:
> > monteExpr( "avgCurrent" "average(clip(IT(\"/V1/PLUS\") 2e-07
> > 3e-07))" )
> > My MC get at the end with no troubles at all.
> > If I dare trying the unescaped syntax as St=E9phane mentioned above,
> > then my ocean yells at me:
> > ;
> > ocean> load("/tmp/monteCarlo.ocn")
> > monteExpr( "avgCurrent" "average(clip(IT("/V1/PLUS") 2e-07
> > 3e-07))" )
> > ^
> > SYNTAX ERROR found at line 19 column 67 of file /tmp/monteCarlo.ocn
> > *Error* lineread/read: syntax error encountered in input
> > *Error* load: error while loading file - "/tmp/monteCarlo.ocn"
> > ;
>
> > Well it did work very fine in my case but you don't care, don't you ?
> > I'm suspecting a spectre/ocean bug so far.
> > You seem you can get access to the cds SourceLink, so why don't you
> > give a look at the SR11297882 to check out your cadence version
> > against a similar problem re****ted in that ticket. Contacting your
> > cadence customer sup****t would be the best thing in this case.
>
> > Cheers,
> > Riad.
>
> Hi Riad,
> Thanks for your reply.
> I'll recheck things and get back to you.
>
> Regards,
> Anand
Thanks to all.
I am able to run my script and get the mean/sigma written down into a
file.
|
