On Sat, 12 Jul 2008 14:56:32 -0700, "over a barrel"
<precisionmachinist@[EMAIL PROTECTED]
> wrote:
>Jon but on reading his blog it sounds to me like a fairly good method
>provided the objective is that of reliably launching plastic plastic
>workpieces out of the machine vise.
>
>Jon suggest rethink and perhaps remove that particular tip of gripping
only
>upon a .030 deep ****tion of work and generating shear with the dove (
rather
>than pure compressive forces )--rather poor and unreliable workholding
>practice, especially where the soft or highly malleable materials are
>concerned....hopefully no one will actually try this and so end up
causing
>themselves or others to suffer personal injury or property damage.
Exactly. Clearly he's never actually done as he claimed & it's
all clueless stolen BS *again*.
He has NO IDEA at all what it was about. Just buzzwords to
steal (again), get confused & garbled about in his little
"rewrite". (I had to read the BS twice.)
--
Cliff
