Re: Shade of doors

Thank you very much, but Nic has found the solution below.

Rafaele

"Nic M." <gd30168@[EMAIL PROTECTED]
> ha scritto nel messaggio
news:40bb6f6d_1@[EMAIL PROTECTED]
> From Zoogdesign By Beegee:
>
> "From memory, it has something to do with the transparency setting which
> causes the door panel to appear to hide elements beyond if the door
swing
is
> cut by a section.
> Open the door family and then go to 3d view and then put the cursor over
the
> head of the opening and tab through until you get the "opening cut"
> selected. Check the option bar and see if the "3d" and "elevation" boxes
are
> checked. If the elevation one isn't checked then that may be the
problem."
>
> Nic

"Scott Davis" <scott@[EMAIL PROTECTED]
> ha scritto nel messaggio
news:40bcb94a$1@[EMAIL PROTECTED]
> That will only hide them in the view.  They will still plot.  Put in a
> request to allow the Hide/Isolate tool to also work for plotted output.
>
> SD
>
> "Arkitekt" <acj_bz@[EMAIL PROTECTED]
> wrote in message
> news:40bca600@[EMAIL PROTECTED]
> > Hi Rafaele,
> >
> > Try selecting the doors in your section view and Hide them using the
> > Hide/Isolate command.
> >
> > Regards,
> >
> > Ak.
> > "Rafaele" <visicaler@[EMAIL PROTECTED]
> wrote in message
> > news:40b8760c@[EMAIL PROTECTED]
> > >
> > > When I make a section, some gray "shades" appear in the section view
> > though
> > > the section plane doesn't touch that doors.
> > >
> > > How can you eliminate that gray doors' shade in the section view?
> > >
> > > Thanks
> > >
> > >
> > >
> > >
> >
> >
>
>