Re: Pick point is off

On Wed, 05 Dec 2007 19:06:51 -0800, coosbaylumberco wrote:

> Whenever I center the little box over a line, instead some line
> underneath the arrow will get picked for alteration. I have tried it a
> few ways now, but it refuses to accept a line within the confines of
> that little box. It will however pick up one a bit away, usually under
> the arrow of the cursor.
> 
> 
> How can I get the sensing point to readjust it self back to the box?
> 
> Wm.

Could it be that you have "PolarTrack" and/or "SnapTrack" on? (I presume
that what you want is to use "Entity Snap"). Those two can be very
confusing if you don't know how they work, or if you are not aware that
they are on. 

I know that BricsCAD comes with those two activated by default in a new
installation.

Simen