On 14 Nov 2006 07:35:02 -0800, coosbaylumberco@[EMAIL PROTECTED]
wrote:
>Humm.....
>
>I found back-up tape with the version of most programs over weekend. I
>asked it to reinstall, jsut in the ICAD area. It prompted me a few
>times to verify any over writting. Including the Icad.dwg file. Overall
>it now seems to be giving no surprizes in the mornings.
>
>Only thing here is that I often work with folks now on Autocad. When I
>bring in their drawings, or open up their drawings for an initital
>check, I get their menu. On occasion, the menu they must be using has
>no shut down or close out features, for that option is gone. I cannot
>get out of the drawing editor. I have to Re-boot in order to get out. I
>can im****t their drawing into an ICAD via XREF or INsert. Nothing
>changes for me at this end.
>
>I want the ICAD menu. Not some foreign one. How then, can I force ICAD
>to open up and use only the ICAD menu? I would like it to hold to the
>ICAD manu under All cir***stances.
>
>
>Wm.
===========
You might want to try setting icad.dwg to read only.
try typing >menu< at the prompt and see if you can load in your
intelicad menu file [autocad menu extension is .mnu, intelicad
menu extension is .icm]
Unka' George (George McDuffee)
...............................
Only in Britain could it be thought
a defect to be "too clever by half."
The probability is that too many people
are too stupid by three-quarters.
John Major (b. 1943),
British Conservative politician, prime minister.
Quoted in: Observer (London, 7 July 1991).
|
