Re: Snap-to Problem

<coosbaylumberco@[EMAIL PROTECTED]
> wrote in message
news:1150678758.920624.20760@[EMAIL PROTECTED]
> Measuring the error of closure is quite easy, for I just construct a
> line from the center of the over to a perpendicular of the line/curve.
> Then zoom in tight and measure away. Also how I find out what is the
> reason why there is no intersection at the locale.
>
Hmm, perhaps it happens on mine & haven't noticed. I wouldn't be sure Icad
sees that as an intersection or would only look for an endpoint. It
sometimes has trouble trimming a circle into an arc between 2 parallel
lines
or splines supposed to be 1 diameter apart. (to represent say a horizontal
pipe elbowing down).