Re: Version compatability

"CW" <s@[EMAIL PROTECTED]
> wrote in message
news:IKrbg.4469$y4.2458@[EMAIL PROTECTED]
> First, stating Intellicad version numbers without specifying who's
version
> is meaningless. Progcad's numbers are different from CMS's, which are
> different from Bricscad, ect. The only compatibility problems you are
likely
> to have is with the DWG version, not Intellicad. Likely the newer
version
is
> saving to DWG2004 by default. Older versions of the software (and older
> versions of AutoCAD) can not read that. In the save dialog, you can set
the
> version when saving. You can also set the program up so it defaults to
any
> version you want. I have mine set to default to DWG2000 to avoid
> compatibility problems like this.
>
RG mentions Cadopia later in post, I believe they started saying winXP was
minimum in the hope it would overcome a few problems people were
experiencing... but it didn't actually and when later versions ironed out
the issues they couldn't really revert & say 98 was ok again.